時間：2011-08-11 18:26來源：藍天飛行翻譯 作者：航空 點擊：次
|
1) 從收藏處取出困難。Difficult to release from stowage 2) 面罩帶無法放。Harness fails to deflate 3) 面罩帶無法充氣。Harness fails to inflate 4) 面罩帶漏氣。Harness leaking 5) 軟管問題。Hose problem 6) 面板（口蓋，銷子等）損壞。Panel (door, pin, etc) damaged 旅客氧氣面罩 passenger oxygen masks 1) 當人工將旅客氧氣電門置于 ON 位時，所有氧氣面罩未脫落。All masks did not drop when PASS OXYGEN switch manually was setted to ON. 2) 氧氣系統自動/人工落下期間旅客氧氣接通燈不亮。PASS OXY ON light was not on during automatic/ manual oxygen system deployment. ATA36 氣源系統 氣源 pneumatics 恒溫器 thermostat 地面氣源 ground pneumatic 超溫電門 over temperature switch 單向活門 check valve 引氣活門 bleed air valve APU引氣活門 APU bleed air valve 引氣隔離活門 bleed air isolation valve 預冷控制活門 precooler control valve 引氣調節器 bleed air regulator 雙壓力指示 dual pressure indicator 總管壓力傳感器 manifold press transmitter 預冷控制活門傳感器 precooler control valve sensor 1) 機組反映空中右發引氣跳開燈亮.The crew reported that the “bleed trip” lights of the R/H engine were on in air. 2) 更換引氣活門 Replace bleed air valve 3) 更換壓力調節關斷活門 Replace the PRSOV 4) 拆除并安裝右發高壓調節器 Remove and install R/H engine high stage regulator 5) 拆除并安裝左發高壓級活門 Remove and install L/H engine high stage valve 6) Do a troubleshooting of R/H engine low pneumatically pressure at low idle排除右發在慢車時引氣壓力低的故障 7) Resolve the troubleshooting of L/H engine low pneumatically pressure at low idle慢車時左發低氣壓排故 ATA38 水和廢物 水箱 water tank 門閂 door Latch 飲用水 potable water 排水口 drain mast 廢物箱 waste tank 真空馬桶 vacuum toilet 加注/溢流活門 fill/overflow valve 球形活門 ball valve 盥洗室門 door to lavatory 盥洗室地板 floor in lavatory 盥洗室鏡子 mirror in lavatory 盥洗室柜頂 countertop in lavatory 盥洗室拉手 grab handle in lavatory 盥洗室供水 water supply in lavatory 盥洗室水龍頭 faucet in lavatory 盥洗室洗手池 sink in lavatory 盥洗室中返回座位標志 Return-to-seat sign in lavatory 盥洗室洗手池下的塞子 Sink drain stopper in lavatory 盥洗室中的垃圾溜槽蓋板Waste chute door in lavatory 水和廢物 water & waste 排放管 drain line 排放接頭 drain fitting |
